Danfield Audio MX10
- product images
- product info
- product specs
On the front, the balanced Mic Input XLR connector is located along with the Phantom Power On/Off Switch. A yellow LED indicates 48V Phantom Power is present.
The red LED monitors clipping (O/L - overload) in the gain stage, and will illuminate at levels 6 dB below the actual clipping point. The gain is adjusted on the 12 step gain switch, giving a range from +9 dB to +73 dB. Trim controls the output stage and is adjustable +/- 5 dB.
Balanced output and mains power connection are placed on the rear of the MX 10.
The basic principle with this microphone amplifier is to treat the sensitive microphone signal in the best possible way from the very beginning. Therefore, a transformer input stage is chosen because of its perfect common mode rejection performance - which simply means that it perfectly 'sorts out' all the signals not actually coming from the original microphone electrical pulses.
A very useful side benefit of the MX10 is the low output impedance of the system. This means that the unit is capable of driving multiple parallel receiving inputs, (etc. Multitrack inputs or Desk inputs), allowing you to avoid time consuming cross patching.
Note:- the MX10 contains fixed High & Lowpass filters, calibrated to deliver very clean and smooth audio transfer - without sub frequencies and with no HF interference. The filter tilt is set to 12 dB/ Oct. - and cannot be disconnected.
The output stages are electronically balanced, but perform like a transformer in order to match the gain structure. In true balanced environments no further precautions are necessary.
Input Transformer: Lundahl LL 1528
Input Impedance: 1000 Ohm
Input Symmetry: > 100dB
Signal / Noise Ratio: - 124 dB
Frequency response: 2 - 49 KHz
Gain Range: +9 - +73 dB
Trim Range: +/- 5 dB
Hi-pass: > 30 Hz
Lo-pass: < 40 KHz
Distortion (1KHz): 0,002 %
Linearity: 0,6 %
Output Impedance: < 30 Ohm (Servo control)
Output Symmetry: > 100dB
Dimensions (L X W X H):
207mm X 103mm X 36.5mm
200 - 240 VAC, 50 Hz ( 50mA)
|Short Description||Portable single channel mic-pre.|
|Demo in Store||N/A|
ADD CUSTOM BUNDLE OF YOUR CHOICE
AND SAVE UP TO 65% ON PLUG-INS
CHOOSE YOUR CUSTOM BUNDLE:
No UAD-2 CUSTOM BUNDLE
Universal Audio UAD Custom 2 Bundle£190.83
SAVE UP TO 25%
Universal Audio UAD Custom 3 Bundle£282.50
SAVE UP TO 33%
Universal Audio UAD Custom 6 Bundle£440.83
SAVE UP TO 50%
Universal Audio UAD Custom 10 Bundle£624.17
SAVE UP TO 60%
Universal Audio UAD Ultimate 5 Upgrade Bundle£3,165.83
SAVE UP TO 65%