DPA ST2006A Stereo Pair Of 2006A Microphones
DPA ST2006A Stereo Pair Of 2006A Microphones
- product Description
- Additional Information
- Reviews
The DPA ST2006A Stereo Pair Twin Diaphragm Omni Microphone is part of the Reference Standard Series and is built around the acclaimed DPA 4006 omni microphone, due to it's sound character and industrial design. The ST2006A is great for miking and recording orchestra, acoustic piano, guitar, wind instruments, vocals and choirs. Complete with Peli transportation case, holders, and windscreens.
The ST2006A from DPA features a Twin Diaphragm Capsule technology. This makes the ST2006A well balanced for acoustic authenticity and true character. The capsules are loaded to the supreme Reference Standard preamps instead of the tiny miniature FET preamp from the miniature mics, offering even more air and precision.
In a 2006 capsule two opposite facing miniature capsules are custom re-built into a double diaphragm, one-capsule composition. This combines the advantages of small capsules (fast impulse response and large frequency bandwidth) with lower inherent noise achieved from a larger diaphragm area.
The main features of the ST2006A include:
Stereo Pair
Directional pattern: Omnidirectional
Principle of operation: Pressure
Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule
Frequency range: 20 Hz to 20 kHz
Frequency range, ± 2 dB: 50 Hz to 20 kHz with typ. 3 dB soft boost at 14 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz: 40 mV/Pa; -28 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 28 dB (max. 30 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 78 dB(A)
Total Harmonic Distortion (THD) at 1 kHz: < 1 % up to 130 dB SPL peak
Minimum load impedance: 2 kohm
Dynamic range: Typ. 114 dB
Max. SPL, peak before clipping: 141 dB
Switchable attenuator: 0 dB / -20 dB
Output impedance: < 200 ohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specification
ns): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Colour: Matte black
Microphone weight: 160 g (5.6 oz)
Microphone diameter: 19 mm (0.75 in)
Microphone length: 164 mm (6.5 in)
Output voltage, RMS: > 5 V
Polarity: +V at Pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
Relative Humidity (RH): Up to 90%
| Short Description | Stereo Pair Of 2006A Microphones, Includes Clips, Windscreens & Hardcase. |
|---|---|
| Demo in Store | N/A |
| Exclusive | N/A |
| Manufacturer | DPA Microphones |
| Microphone Type | Small Diaphragm Condenser |
| Valve / Solid State | Solid State |
| Microphone Polarity | No |
| Phantom Power | No |
| Frequency Response | No |
| High Pass Filter | No |
| Output Impedance | No |
Write Your Own Review
Only registered users can write reviews. Please, log in or register
