DPA ST2011A Stereo Pair Of 2011A Microphones

The DPA ST2011A Stereo Pair Twin Diaphragm Cardioid Microphones are part of the Reference Standard Series. Built around the acclaimed DPA 4011 cardioid microphone, the 2011A can be used for multiple applications, and to capture the true stereo field. The ST2011A delivers a blend of clarity, richness and dynamic range. Great for miking and recording on stage and in the studio. Complete with Peli case, holders, and windscreens.

The ST2011A from DPA features a Twin Diaphragm Capsule technology. In a 2011 capsule, two opposite-facing miniature capsules are custom re-built into a double diaphragm, one-capsule composition. The capsules are loaded to the supreme Reference Standard preamps instead of the tiny miniature FET preamp from the miniature mics, offering, even more, air and precision.

In a 2011 capsule, two opposite-facing miniature capsules are custom re-built into a double diaphragm, one-capsule composition.

Specifications:

• Stereo Pair with 2011A Cardioids
• Directional pattern: Cardioid
• Principle of operation: Pressure gradient, with an interference tube
• Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule
• Frequency range: 20 Hz to 20 kHz
• Frequency range, ± 2 dB, at 30 cm: 50 Hz to 17 kHz with 3 dB soft boost at 12 kHz
• Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
• Equivalent noise level, A-weighted: Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A))
• Equivalent noise level, ITU-R BS.468-4: Typ. 33 dB (max. 36 dB)
• S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 74 dB(A)
• Total Harmonic Distortion (THD) at 1 kHz: < 1 % up to 137 dB SPL peak
• Minimum load impedance: 2 kohm
• Dynamic range: Typ. 117 dB
• Max. SPL, peak before clipping: 153 dB
• Switchable attenuator: 0 dB / -20 dB
• Output impedance: < 200 ohm
• Cable drive capability: 100 m (328 ft)
• Output balance principle: Impedance balancing with Active Drive
• Common Mode Rejection Ratio (CMRR): > 60 dB
• Power supply (for full specifications): 48 V Phantom power (± 4 V)
• Current consumption: 2.8 mA
• Connector : XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
• Color: Matte black
• Microphone weight: 164 g (5.8 oz)
• Microphone diameter: 19 mm (0.75 in)
• Microphone length: 198 mm (7.8 in)
• Output voltage, RMS: > 5 V
• Polarity: +V at Pin 2 for positive sound pressure
• Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
• Relative Humidity (RH): Up to 90%