020 84452446
Nagra LB

Nagra LB

  • product images
  • product info
  • product specs
  • reviews
  • media

Nagra LB

Product description
The NAGRA LB has been designed as the natural successor to the ARES-C and the ARES-BB+ recorders, and it is specifically designed for broadcast applications although naturally it is also very well suited to a multitude of other recording applications. Similar in size to the ARES-BB+ the LB offers communication possibilities never before seen in a professional broadcast recorder.

Audio inputs
It offers two analogue audio inputs and a single stereo digital input. The Nagra LB will record in either PCM linear audio or in MPEG-1 layer II or MP-3 compressed audio formats. The inputs are equipped with traditional NAGRA microphone pre-amplifiers for dynamic and phantom +48V microphones. The LINE input will accept up to +24dB. The audio levels and current operating mode of the recorder are shown on the colour display mounted on the front of the unit. Above the potentiometers three leds are fitted to indicate audio levels as on the ARES-PII+, BB+ and Nagra VI. The front display becomes inactive when the editor on the top panel of the machine is in use.

The Nagra LB is fitted with an internal 2GB NAND flash memory which serves two important roles. Firstly as a back-up media should the extractable compact flash card be full, but also as a spontaneous memory for recording while the extractable card is changed. Simply pressing the "Hot Swap" button next to the slot will open a 30 second window allowing the inserted card to be replaced even while the recorder is actually recording.

Editing and communication
The top of the LB is equipped with a built-in audio editing system with its own dedicated colour display. It allows editing of broadcast wave MPEG 1 layer II files and 16 bit PCM files at 32 and 48 kHz. Thus in-the-field editing i spossible and gives a graphic waveform display. Once the editing of the audio material is complete, the file can be transmitted to the studio either over IP (through the ethernet connection using the File Transfer Protocol "FTP" connection) or via a GSM phone through the Bluetooth option. Naturally the USB port also serves as a generic drive when connected to a computer to file transfer can also be done this way. Removal of the compact flash card is a final possibility for removing the audio from the recorder. The HOST USB port can also be used for an external memory stick for file transfer.

The LB is powered by 8 "AA" batteries in a removable battery compartment. This may be fitted with rechargeable cells if required, which are in turn charged through the Hirose connector on the battery box body using the built-in charger circuit.
Technical Specifications

Internal storage 2 GB NAND Flash memory
Removable media Compact Flash type II / III (Hot Swappable)
Disk format FAT 16 / 32
Recording Method Linear digital PCM, MPEG 1 layer 2 or MP-3
File type 16 / 24 bit Broadcast Wave File BWF (WAV)
A/D & D/A conversion 24 Bit Sigma Delta
Bit rates 32 kbits/s up to 384 kbits/sec
Tracks 2 individual
Sampling Rate 44.1, 48 kHz, 88.2, 96 and 192kHz
Recording capacity 1hr 24 bit 48 kHz per GB of disk / memory
Pre-recording buffer Programmable (Maximum 3 seconds)
Display 2 x Colour LCD
Level meters On colour display AND by LED

Digital input XLR 3-pole
Analogue inputs

2 x XLR Microphone (Dynamic, +48V Phantom) / line
Microphone input sensitivity 2 and 15 mV/Pa selectable
Limiters On microphone inputs
Line input sensitivity Adjustable from -6 dBm up to +24 dBm for 0 dBFS recording
THD at 1 kHz <0.1% Mic, <0.01% line (measured on AES out)
Frequency response Mic, 10Hz - 48 kHz ± 0.5 dB, Line ±0.2 dB (measured on AES out)
Signal-to-noise ratio >100 dB
Input level adjustment range 50 dB Mic and from -6 to +24 dB Line
Input filters LFA (with vortex filtering)
Internal microphone Electret on the front panel

Analogue line output XLR 4.4V max (+15 dBm)
Digital output XLR AES-3 (24 bit or 16 bit)
Headphones Stereo 6.3mm (¼”) Jack 50 Ω
Internal speaker 0.2W

USB Host USB 2.0 connector type "A"
USB Device USB 2.0 connector type "B"
M/S Decoder Switchable
Ethernet RJ 45

Dimensions 175 x 65 x 185mm (W x H x D) (Incl. battery box)
Weight 1.4 kg (3 lbs) (Incl. batteries)
Power supply External 9 - 15V
Power Consumption Approximately 2W (160mA on 12V)
Charge time Approximately 3 hours (with NimH cells)
Battery life

8 hours (8 x NiMh 2500 mAh) Record @ 24 bits 48 kHz with 2 x phantom +48V (2 x 4 mA), continuous recording. Between 5 and 5 1/2 hours with 8 x LR6 dry alkaline cells.
Relative humidity From 10% to 99% (non condensing)
Short Description Two track digital recorder. Comes with battery box, mains power supply, bluetooth communications key, carrying case and instruction manual on CD.
Demo in Store N/A
Manufacturer Nagra
Old Price N/A

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Got a question about this product? We have the answer. CALL US: 020 84452446
contact Us
Inc. VAT: £2,562.00 Ex. VAT: £2,135.00
Usually shipped in 1-3 days.
From per month

  • Related items / Alternative products
Digital & Analogue Audio Recording Studio Equipment from Uk & Europe’s Premiere Audio Gear Supplier - KMR Audio 2005-2015 - All Rights Reserved and Are Property of Respective Owners. Errors and omission excepted. Use of the site is governed by our terms and conditions.