SPL 2Control

monitor Controller

CAP2: 0 £568.99
£474.16 ex VAT
Call or Email for availability.

The SPL 2Control Analogue Monitor Controller has a unique Crossfeed control that allows you to judge a stereo panorama on headphones, just like with loudspeakers.

At a glance

  • Two channels, Two sources, Two loudspeaker sets, Two headphones
  • Analogue volume control for your DAW
  • Two excellent headphone amplifiers
  • Crossfeed control
  • Extend the range of headphone applications
  • High-grade balancing stages
  • Unbalanced connection (e.g. RCA, TS Jack)
  • Separate mono speaker output
  • Input sockets: XLR
  • Output sockets: XLR, Stereo TRS
  • Nominal input level: IN 1: +4dBu, IN 2: +4dBu/-10dBV
  • Input impedance: 22kOhm
  • Output impedance: 75Ohm/Headphones: 22Ohm
  • Max. input level: 21,3dBu
  • Max. output level: 21,3dBu
  • Volume control range: -80dB to +6,6dB
  • Headphones: -65dB to +14,9dB
  • Frequency range: 10Hz to 100kHz (-3dB)
  • CMRR: ›60dB (@1kHz, 0dBu input level, unity gain)
  • THD: 0,002% (@1kHz, 0dBu input level, unity gain)
  • Signal to noise ratio: -96dB/Headphones: -85dB (A-weighted)
  • Crosstalk L/R: ›70dB (@1kHz)
  • Dynamic range: 116dB
  • Power consumption: ca. 25W
  • Features: Toroidal transformer with voltage selector
  • Fuses (slow blow): 230V/50Hz: 315mA, 120V/60Hz: 630mA
  • Dimensions: (WxHxD): 215x80x220mm
  • Weight: 2,1kg

The SPL 2Control Analogue Monitor Controller has a unique Crossfeed control that allows you to judge a stereo panorama on headphones, just like with loudspeakers.

The concept of the SPL 2 Control is based on a dual-channel operation that allows for connection of two sources, two stereo speaker sets and two headphones. Each of the three speaker outputs (2 stereo sets, 1 x mono speaker) is driven by its own balancing stage to exclude signal degrading mutual influences. Each headphone output is supplied by a separate amplifier to allow for completely independent operation of two headphones without any interaction from the other output.

A new feature of the 2Control is the Crossfeed control for both headphone outputs, which was derived from the high-end headphone amplifier Phonitor. From their principle, headphones have the disadvantage of producing a 180 degree stereo panorama – the Crossfeed control can be used to adjust a stereo panorama that corresponds to a stereo speaker image.

Alternative Products